-----Original Message----- From: Bill Gunshannon [mailto:bill@cs.scranton.edu] Sent: Thursday, February 27, 2003 4:08 PM To: pups(a)minnie.tuhs.org Subject: [pups] 2.11 on an 11/44 I am trying to put 2.11 on one of my 11/44's. I picked up the RL02/RK images from the archive. I put the RL02 images on real RL02's (Yes, some of us still have and use them!! :-) My intent was to boot this and then use it to build a system on a bigger disk and then go on from there. Here's my configuration: 11/44 CPU CIS EIS FP11 4M memory (actually 3840KB) MMU 3 RL02 disks A CDU/720-TM SCSI Controller with 4 MAXTOR 340M disks and a QIC tape Now the problem. The system boots fine. And it will mount /dev/rl1a. But it won't mount /dev/rl2a. I get "/dev/rl2a on /vol2: No such device or address". I get the same error when I try to do a disklabel. What's more, I also get this same error when I try to access any of the RA devices. I am using the GENERIC Kernel which I assume has all the devices in it. Anybody have any suggestions?? Of course, if I find that the SCSI Controller isn't going to work I have another controller and a FUJI Eagle I could use too. But I am certain I will need to get all three RL's working in order to have enough of a system to do this. Thanks in advance, bill -- Bill Gunshannon | de-moc-ra-cy (di mok' ra see) n. Three wolves bill(a)cs.scranton.edu | and a sheep voting on what's for dinner. University of Scranton | Scranton, Pennsylvania | #include <std.disclaimer.h> _______________________________________________ PUPS mailing list PUPS(a)minnie.tuhs.org http://minnie.tuhs.org/mailman/listinfo/pups