Re: [TUHS] papers on the -mm macros? - TUHS

26 May 2006

OK, so I'm wwwwwaaaaaaayyyyyyy behind on reading TUHS.

I just wanted to say that if you can find a copy of the third edition
of "Unix In A Nutshell" (NOT the current fourth edition) you'll find
a chapter on the MM macros. It should be enough to make use of them,
as I did buy one of the SysIII licenses and I have a copy of this paper
that I referred to when writing that chapter.

And groff did do a good enough job formatting it that I was able
to print it out and it looked reasonable if not perfect. (Of course,
that was circa 1999...)

If I ever Get A Round Tuit I want to take the troff material from that
edition and do it as an ebook for O'Reilly. But I don't know when or
even if that'll ever happen.

Arnold

...
  Date: Sat, 11 Mar 2006 15:25:49 +0100
 From: Gunnar Ritter &lt;gunnarr(a)acm.org&gt;
 Subject: Re: [TUHS] papers on the -mm macros?
 To: tuhs(a)minnie.tuhs.org, "A. Wik" &lt;aw(a)aw.gs&gt;

 "A. Wik" &lt;aw(a)aw.gs&gt; wrote:

  I've found the documentation for most of the
major
 troff preprocessors and macros packages, but I can't
 seem to find anything but occasional references to a
 paper on the "Programmer's Memorandum Macros" (troff -mm)
 by Smith and Mashey. 
 The source code for this paper had been available as part
 of the System III distribution under the old (unfree) SCO
 license.

 In case you had applied for that license, and you still
 have an old PUPS archive CD at hand, you can find it in
 Distributions/usdl/SysIII/sys3.tar.gz.

 You will not be able to recover the original layout since
 PostScript font metrics are quite different from CAT ones,
 but Heirloom troff produces readable output at least.

 	Gunnar 