Ah, you're all set, then - doubly so, in fact. Not only do you have reliable mass storage, but you should be able to put the Unix filesystem on an SD card, to get the bits into the machine. I'm not familiar with that board, but it sounds pretty good; QBUS<->SD. I don't know how that board uses the SD card, in terms of where it keeps the RL02 image, but if you can find that out, SD<->USB3 adaptors are cheap and plentiful, and it shouldn't be too hard to load the disk image into it using one of them. (For the QSIC, I found a 'dd' for Winsdoze and used that to write the disk image onto the SD card.) Not a problem: if you hook up the -11's console to another computer, you can download a bootstrap into it over the serial line, using the -11's ODT. (There's a page here: http://gunkies.org/wiki/Running_an_LSI-11_from_Unix_V6 which talks briefly about how to do that. Things like PDP11GUI can do it too, I think.) I don't use an RK bootstrap in ROM to boot from the emulated RK11 on the QSIC; I just load in a short RK bootstrap. I don't know of one lying around for the RL11, but one would be trivial to whip up. Speaking of booting, I have Mini-Uix booting under an -11/05 simulator (Ersatz-11); I used the RK image from here: http://www.tavi.co.uk/unixhistory/mini-unix/munixrks.zip and it just started right up. So that's the big hurdle; been busy with other stuff, but I'll work on getting it to boot on an '03 'soon'. You probably want to do the same; having it running under a simulator will make it easy to build new OS images, e.g. for a system with RL02's. Build the new system, name it 'rlmx', copy the simulator disk image into the SD card, and away you go. Oh, I recently realized how to make a bit more room on an -11/03: most DEC small QBUS memory cards allow you to use half the 'I/O page' for memory, if you need it. I.e. instead of having 56KB of memory, and 8 KB of address space for device registers (a lot more than is really needed), the memory can be configured to be 60KB of memory. It can be a bit of a hassle to use it; to have more room for the OS (for more drivers, or disk buffers, or whatever), some pieces of Mini-Unix need to be recompiled, to move up the address where user processes are loaded. Larger user processes are the same thing; they aren't automatically enabled when there's more memory, you have to change a config file, recompile some things, and build a new system. What kind of memory card(s) do you have for the -11/03? Noel