s/to detail/to deal with/ - I hate autocorrect
ᐧ
On Wed, Aug 14, 2024 at 2:50 PM Clem Cole <clemc(a)ccc.com> wrote:
On Wed, Aug 14, 2024 at 2:18 PM Steffen Nurpmeso <steffen(a)sdaoden.eu>
wrote:
Depending on what you mean by "at that
point" i think here you
misremember. (To the contrary 733 and also 822 allow practically
anything
Page 3 of SMTPD -- RFC 821 [which the 822 sits on top of says]:
"Commands and Replies are composed of characters from the ASCII character
set. When a transport service provides an 8-bit byte (octet) transmission
channel, each 7-bit character is transmitted right justified in an octet
with the *high order bit cleared to zero*"
BTW, this was specified in 821 because it had been a factor in earlier
experience of the ARPANET [733 and using FTP as a mail transport, which was
how much of this all started], and binary was explicitly not allowed. 822
force 7-bit ASCII because of the earlier issues of things like CDC's
display code (what a nightmare), much less EBCDIC. The key was that those
of us in the ARPANET community could not allow "anything," - but we did
have to detail what was there.
Some of us lived in this world and wrote programs that dealt with those
constraints at the time. I am relaying to you what it was and how it
happened. As I said, we have what we have because that was what we were
living with -- two distinct worlds, the ARPANET community - which was
setting the standards for interchange, and UNIX (USENET), which was de
facto and growing because it cost little to join it.
As a remark, the MBOX format as standardized by
POSIX decades ago
Ouch -- I was part of POSIX and /usr/group before that. And had
>nothing<< to do with it. The POSIX
definition was at least 15 years
After Bruce wrote MH and Kurt did delivermail and
if I count I >>suspect<<
it is correctly closer to 20-25. mbox was created I believe by Ken (Doug
do you remember?), but I'm not sure who actually wrote the original
"mail"
program for Fifth edition (maybe Fourth) - which as I said was both an MUI
and a MTA. But that development was over 15 yrs before we started the
/usr/group standard, much less the POSIX ones.
You are probably correct that until it was formally specified in the POSIX
definition, the format was defined originally in Ken's code, then Kurt's
and finally in Eric's. IIRC, Bruce actually had a man page in MH that
described his format that used the ^A characters, but I would have to
rummage through old sources to be 100% certain. Certainly, later
distributions of it did describe it, and MMDF may have also - but I'm not
sure.
BTW: by about 4.2BSD time (maybe a little earlier), particularly because
of sendmail - the MH system (which had left Rand and was then being
supported by someone else ??UC Irvine maybe??) had been hacked to handle
the mbox format
ᐧ