30 Jan
2002
30 Jan
'02
4:13 a.m.
On Jan 27, 23:42, lothar felten wrote:
installation was no problem, but still i
have some questions:
my VT102 doesn´t do backspace, i only
get ^H. i tried the
terminal in ANSI and VT52 mode, no
difference.
Maybe it wants a DEL character instead of backspace (backspace *is* ctrl-H,
shown as ^H or ^h). Change it on the terminal by going into setup, or use
stty on the BSD system to change the delete character (stty del '^h').
i have some dec boards labeled M7513
does anyone know what this
is? i found:
M7513 - RQD - RQDXE Q BUS drive
interface extension module
That's exactly what it is. The BA23 box only supports one hard drive; the
RQDXE is an adaptor for an RXDX2 or RXDX3 to permit use of additional
drives with a distribution board in a second enclosure. One of the 50-pin
connectors goes to the RQDX3, one to the distribution board in the BA23,
and the third to a connector kit on the rear panel of the BA23. There's a
different version for an RQDX1, called an RQDX1E.
the RQDX3 has another connector, i
suppose for RX50 floppydrive.
An RQDX3 has only one connector, the 50-pin one to go to the distribution
board. Are you looking at the right thing? Are you looking at a
distribution board? That does have a 34-way connector for a floppy.
can i hook up a 5,25" pc drive? maybe
with modifications?
Not an ordinary PC floppy, no. A TEAC FD55GFR is an 80-track double-sided
drive (not HD, though) that will work as an RX33. Some other 80-track
5.25" drives may work, if you set the jumpers.
--
Pete Peter Turnbull
Network Manager
University of York