9 Jan
2015
9 Jan
'15
7:18 a.m.
From: Mark Longridge <cubexyz(a)gmail.com>
I've finally managed to get Unix v5 and v6 to go
into single user mode
while running under simh.
...
dep system sr 173030 (simh command)
Just out of curiousity, why don't you set the SR before you boot the machine?
That way it'll come up single user, and you can icheck/dcheck before you go
to multi-user mode. I prefer doing it that way, there's as little as possible
going on, in case the disk is slightly 'confused', so less chance any bit-rot
will spread...
Now I'm in muti user mode .. but then if I do a
"ps -alx" I get:
TTY F S UID PID PRI ADDR SZ WCHAN COMMAND
?: 3 S 0 0-100 1227 2 5676 ????
?: 1 W 0 1 40 1324 6 5740 -
The ps command doesn't show the /etc/init process
explicitly, although
I'm pretty sure it is running.
No, it's there: the second line (PID 1). For some reason, the code for
/etc/init (in V6 at least, I don't know anything about V5) bashes the command
line so it just has '-' in it, so it looks just like a shell.
I fixed my copy so it says "/etc/init", or something like that. The machine
my source is on is powered down at the moment; if you want, I can upload the
'fixed' code tomorrow.
I'm not sure if unix of the v6 or v5 era was
designed to go from multi
user to single user mode and then back again.
I seem to recall there's some issue, something like in some cases there's an
extra shell left running attached to the console, but I don't recall the
details (too lazy to look for the note I made about the bug; I can look it up
if you really want to know).
Would it be safer to just go to single user and then
shut it down?
I don't usually bother; I just log out all the shells except the one on the
console, so the machine is basically idle; then do a 'sync', and shortly
after than completes, I just halt the machine.
Noel