2 May
2008
2 May
'08
8:50 p.m.
Tim Newsham wrote:
There was previously a "read:" in u6.s, but it turned out to be
a typo for "readi". I think its safe to use "read" now.
ah ok, thanks.
Btw, I built from latest sources and installed into
simh and
ran and got some action on rf0 but I don't see any non-zero bytes
in the image after running. It ended up in panic. Is it possible
you have some changes that arent checked in?
I don't think so, but I'll check. I think all I did was set cold=1
and rebuilt. Make sure you use my "eae" version of simh.
I'm building with the v7 asm and using "ml" to process the a.out
I am using the clean sources with the addition of
"read" in sys1.s,
an extra line of "4;4;unkni;0;fpsym;0" in u0.s and "cold = 1" instead
of zero.
yes, that seems right.
set cpu 11/20
set cpu 32K
set rk3 enabled
att rk3 rk0.dsk
set rf 2p
set rf enabled
attach rf rf0.dsk
set tc enabled
att tc tape.tc
set hk disabled
set rha disabled
set tm disabled
set rx disabled
set rl disabled
set tq disabled
set tc enabled
set rf enabled
set ke enabled
set cpu history=1000
d pc 400
[... lots of lines to deposit a.out into memory...]
That looks ok. I don't have tc setup, but that should not matter.
I built as "as - sys1.s u?.s".
same here, but I don't add the "-" (not sure what that does)
I run with "go" and then after the first halt
"go" again. Hitting
^E after waiting a while shows that its looping in panic.
Try "det rf". I noticed that the RF device is buffered in ram
and I'm not sure it gets flushed until you detach.
-brad