[pups] 2.11BSD device config trouble
Steven M. Schultz
sms at 2BSD.COM
Thu May 1 02:03:40 AEST 2003
> From: David Evans <dfevans at bbcr.uwaterloo.ca>
> > cn 1 176540 344 5 cnrint cnxint
> to the end of this line? Perhaps the autoconfig parser becomes confused
> if there aren't any.
I don't think that's the problem in this case - the error that is
being printed out:
cn 1 csr 176540 vector 344 no address found for kl/dl-11
comes from what appears to be a missing entry (or an entry that
autoconfig can't find) in the /unix kernel symbol table. One way,
I think, this can happen is when booting an alternate kernel (/genunix
instead of /unix).
THe only suggestion I have at this point is to turn on debugging
in autoconfig. To do this go into /sys/autoconfig/main.c and
add a line that forces 'debug = 1;', then install (after saving the
original ;)) autoconfig into /etc and reboot. Hopefully useful
info about what autoconfig is doing will be printed.
> Mine is at least correctly identified by autoconfig, though I've never
> attached a terminal to it to see whether the ports actually do anything.
> The post that's vanished included my dhv line from /etc/dtab but, except
> for the goofy CSR I used for some reason that I cannot now remember, it
If I find the time I'll power up the 11/73 and see what it says but
I've had a DHV11 on the system for years (it's how I got the RTS/CTS
flow control working).
My suspicion is that the DHV clone isn't behaving 100% like a DEC
> > BTW: Never play with the SMD cables when the machine is running. Now I
> > get:
> Is the disk write-inhibited?
Doing a 'reboot' (which performs a sync(2) call) will overwrite
what fsck has done - when the message about "reboot" comes out you
should use the front panel or ODT to simply halt the cpu and then
start the boot process cold.
More information about the TUHS