[pups] 2.11 on an 11/44
bill at cs.scranton.edu
Fri Feb 28 01:08:26 AEST 2003
I am trying to put 2.11 on one of my 11/44's. I picked up the RL02/RK
images from the archive. I put the RL02 images on real RL02's (Yes,
some of us still have and use them!! :-) My intent was to boot this
and then use it to build a system on a bigger disk and then go on from
Here's my configuration:
4M memory (actually 3840KB)
3 RL02 disks
A CDU/720-TM SCSI Controller with 4 MAXTOR 340M disks and a QIC tape
Now the problem.
The system boots fine. And it will mount /dev/rl1a. But it won't mount
/dev/rl2a. I get "/dev/rl2a on /vol2: No such device or address".
I get the same error when I try to do a disklabel. What's more, I also
get this same error when I try to access any of the RA devices. I am
using the GENERIC Kernel which I assume has all the devices in it.
Anybody have any suggestions??
Of course, if I find that the SCSI Controller isn't going to work
I have another controller and a FUJI Eagle I could use too. But I
am certain I will need to get all three RL's working in order to
have enough of a system to do this.
Thanks in advance,
Bill Gunshannon | de-moc-ra-cy (di mok' ra see) n. Three wolves
bill at cs.scranton.edu | and a sheep voting on what's for dinner.
University of Scranton |
Scranton, Pennsylvania | #include <std.disclaimer.h>
More information about the TUHS